Custom XML values not appearing

General
1

Hi I have a Link ECU in the car using the can analyzer all setup with the base settings. Since i have additional sensors connected to the car along with a few DI/An buttons i wanted to setup i was exploring using the custom XML route. However after i import my xml the new values do not appear in the input selection.

below is a link to my XML, note i do not receive any errors when uploading it

2

I have solved it. After looking through other topics i discovered that i had 2 declarations of frames in my XML so real dash was not reading my 2nd set of frames. I still need to test it on the car but i now see all the values load in on my computer version

1 Like