Highlighting in CAN MONITOR

CoTECH · October 16, 2020, 4:54pm

does not work correctly! The selection is not shown. thus it is not clear which byte is allocated or not
P.S.
If clicking with the mouse does not work, if you pull the mouse, then it works))

and if it’s not difficult, move the window at a frame rate somewhere to the top)))

realdashdev · October 17, 2020, 9:36am

So you mean that selecting bytes in CAN monitor does not work with mouse, but works with touch?

CoTECH · October 17, 2020, 10:27am

Not really!
I only use a mouse!
Clicking on a byte does not make it highlighted!
Byte swipe works correctly!

realdashdev · October 17, 2020, 1:09pm

Fixed on next version. CAN monitor single byte can be selected just by clicking on it. Selecting multiple bytes still requires drag.

CoTECH · October 17, 2020, 3:08pm

thanks

Simon_Ru · November 25, 2020, 8:36am

Hello! 1.8.3 byte order type(endianess) swapped in CAN monitor. From xml to dash works correctly.

realdashdev · November 25, 2020, 9:26am

Ok thanks. Will check.